Lecol 5500 Adhesive 25kg

Lecol 5500 25kg

Lecol 5500 Adhesive is solvent-based and can be used for all types of wood. It is suitable for installation on absorbent and non-absorbent subfloors meaning that it can be universally applied. In many cases this adhesive can even be used to install pre-finished parquet without any problems.


Advantages of Lecol 5500 Adhesive:

• Universally applicable

• Ready to use

• Very strong adhesion

• High filling capacity

• High level of initial grab

• Can be used with underfloor heating - see below

• Consumption per m2: 0.9 kg

• Widely used by professional floor installers

• Supplied in a 25kg tin.

Underfloor heating
Lecol 5500 can be used with underfloor heating. Before laying, the heater should have been in service for at least ten days. Turn the heating off 2 days before laying or lower the thermostat in winter. Switch the heating back on again at a low setting 3 days after laying.




PLEASE NOTE: This product comes in a trade tin that may be vulnerable to dents during transportation by our courier. If your tin is dented during transit, in most cases it will be only superficial damage to the tin leaving the product itself still fully sealed and usable.